Texture Wrap Modes
As described earlier, the (u, v) texture coordinates that you assign to your vertices are what determines how the texture fits on your geometry. Often, you will use texture coordinates that always fall within the range [0, 1], which is the complete range of the pixels of your texture image. However, it is also legal to use texture coordinates that go outside this range; you can have negative values, for instance, or numbers higher than 1.
So if the texture image is only defined over the range [0, 1], what does the texture look like outside this range? You can specify this with the texture wrap mode.
The wrap_mode parameter is specified separately for the u and v directions
(there is also a
setWrapW() for 3-D textures, but
that’s an advanced topic). The wrapMode may be any of the following values:
The texture image repeats to infinity.
The last pixel of the texture image stretches out to infinity.
The color specified by
texture.setBorderColor()is used to fill the space.
The texture image flips back-and-forth to infinity.
The texture image flips backwards, once, and then the “border color” is used.
The default wrap mode is
Consider the following simple texture image:
We will apply this texture in the center of a large polygon whose texture coordinates range considerably farther than [0, 1] in both directions.
WM_repeat mode is often used to
tile a relatively small texture over a large surface.
WM_clamp mode is rarely used on large polygons because, frankly, it looks
terrible when the pixels stretch out to infinity like this; but this mode is
usually the right choice when the texture exactly fills its polygon (see One
caution about a common wrap error, below).
texture.setWrapU(Texture.WM_border_color) texture.setWrapV(Texture.WM_border_color) texture.setBorderColor((0.4, 0.5, 1, 1))
The above blue color was chosen for illustration purposes; you can use any color you like for the border color. (However, some hardware may not efficiently support a border color other than opaque white, transparent white, opaque black and transparent black.) Normally, you would use the background color of the texture as the border color, like this:
Some very old graphics drivers don’t support
WM_border_color. In this case,
Panda3D will fall back to
WM_clamp, which will look similar as long as there
is a sufficient margin of background color around the edge of your texture
(unlike our sample texture, which goes all the way out the edge).
Many older graphics drivers do not support
WM_mirror. In this case, Panda3D
will fall back to
texture.setWrapU(Texture.WM_mirror_once) texture.setWrapV(Texture.WM_mirror_once) texture.setBorderColor((0.4, 0.5, 1, 1))
Few graphics drivers support
WM_mirror_once. In this case, Panda3D will fall
Setting different wrap modes
It is possible to set different wrap modes in the u and v directions:
One caution about a common wrap mode error
When you apply a texture that is intended to exactly fill a polygon–that is, the texture coordinates range from 0 to 1, but no further–you should usually set its wrap mode to clamp. This is because if you let it keep the default value of repeat, the color may bleed in from the opposite edge, producing a thin line along the edge of your polygon, like this:
This is a particularly common error with a texture that is painted as an alpha
cutout, where there is an image with a fully transparent background: you will
often see a thin, barely-visible edge floating along the top (for instance) of
the polygon. This edge is actually the bottom edge of the texture bleeding onto
the top, because the designer specified
WM_repeat instead of the correct